A Clean Connection (Battery Cleaning)

A clean connection is a wonderful thing.  Think of a good cell phone signal or an airline connection with ample time and short distance to the next gate. Good connections are also important for your vehicle’s battery, and one secret to that is to make sure it’s periodically cleaned.

If it’s been a while since you have had any service to your battery, bring it in so we can inspect it for any corrosion that might have formed.  Corrosion on the battery terminals will affect the connection between the battery and your vehicle’s electrical system. The amount of corrosion you can expect can be influenced by such things as the kind of climate you live in (dry or humid, warm or cold), if there’s lots of salt on the roads and how old your battery is.  

We have tools and chemicals to safely remove the corrosion for an optimal electrical connection. In order to reduce the amount of corrosion re-forming on the battery, we’ll apply a special protective coating.  

It’s also important to have your battery tested, especially if it’s more than a few years old or hasn’t been tested in a while.  Our equipment can measure how well a battery holds a charge and how much more life you should expect from it. We can discuss when you might expect to buy a new one, since a battery is definitely the kind of thing you don’t want to have fail you when you’re least expecting it.

Spring Street Automotive Inc
1701 Spring Street
Quincy, IL 62301
217-228-9141
http://www.springstreetauto.com

No Fueling! (Fuel Filler Location)

If you've ever gotten in an unfamiliar vehicle, maybe a rental car, you may have pulled up to the gas pump and wondered, "Which side is the fuel filler on?" Here's a tip for you.  There is usually a little arrow on the instrument panel near the fuel gauge that points to the side where the fuel filler is. 

But why are the fuel fillers not all on the same side, anyway? There are lots of reasons.  At one time, many manufacturers tried putting them in an easy-to-reach spot: in the center of the vehicle's rear end.  Some even hid them behind a hinged license plate door.  Cool place, but it turned out not to be a good idea.  When a vehicle with a fuel filler in the rear was hit by another vehicle from behind, it was much more prone to catch fire and explode.

Safety regulations now dictate that the fuel filler doors be placed within crumple zones and away from where they can drip fuel on hot exhaust pipes or near electrical connections.  But why do manufacturers put them on either side?

Some say it should be on the side away from the road.  That way if you run out of gas and have to add a little from a gas can as your standing at the side of the road, you'll be a little farther away from passing traffic.  So some companies from North America and many European firms with left-hand drive put their fillers on the right side.

Some manufacturers think convenience for the driver is paramount, so they put their fuel fillers on the driver's side.  If you have a vehicle with a cable release for the fuel door inside the cabin, it's usually on the same side as the steering wheel.  As you can see, there's no standardization.

Fuel doors need regular maintenance such as lubrication, and your gas cap (if your vehicle has one) should seal properly.  Have your service facility inspect those regularly. Wherever your fuel filler is, it's obviously important that you can get at it easily because you have to fuel up sometime. Otherwise, you're not going to go too far!

Spring Street Automotive Inc
1701 Spring Street
Quincy, IL 62301
217-228-9141
http://www.springstreetauto.com

Heat and your Tires (Tire Pressure Monitoring System)

With hotter weather and brutal heat waves becoming more common, the pressure in your vehicle's tires goes up.  After all, heat causes air to expand, and the air in your tires follows the laws of physics. Overinflated tires can reduce your vehicle's traction, cause a hard, punishing ride and make your tires wear out faster; all are important safety issues.

Four out of every ten drivers rarely check tire pressure. Some rely on their vehicle's tire pressure monitoring system (TPMS) to keep an eye on proper tire inflation.  But it's not designed to do that.

TPMS is a safety feature that has been required on vehicles made in 2008 or later, using sensors in the wheels that alert you to tire pressure problems.  That warning can be a light on your dash, a digital message or a readout of the pressure in each individual wheel.  But a study showed that more than 40 percent of drivers don't even know what the tire pressure monitoring light symbol looks like!

One looks like a horseshoe with an exclamation point in the middle.  The other looks like an overhead view of your vehicle with the tires at all four corners.  They may even show the inflation number (usually in pounds per square inch, or PSI).

The TPMS is designed to alert you that your tires aren't inflated within certain parameters, but the system shouldn't be a substitute for frequently having your tires checked with a tire gauge.  A TPMS light is only required to come on when a tire is 25 percent under the recommended tire pressure; by that time, you're driving on an unsafe tire and causing excessive wear.

Have your vehicle checked regularly by our professionals, and that includes tire pressure checks.  If you do see the tire pressure warning come on, have our service center look at it soon.  You may have a tire with a problem or the TPMS system may not be working right. 

Either way, since your tires are the only contact your vehicle has with the road, your safety depends a great deal on your tires being in top shape and correctly inflated.  Keep your tires properly inflated and your TPMS working to alert you of any problems. And that's not just a lot of hot air.   

Spring Street Automotive Inc
1701 Spring Street
Quincy, IL 62301
217-228-9141
http://www.springstreetauto.com