Poor Reflections (Door Mirror Problems)

Mirror, mirror on the door, why is my vision there so poor? Well, you could have a broken outside rearview mirror that's disabled your blind spot vision there and endangering your ability to see some of the traffic around you. 

Outside rearview (or door) mirrors are important safety devices that are thoughtfully designed to help drivers see.  And there are a variety of ways those door mirrors can develop problems.

One is when the glass is broken in them.  Sometimes it's caused by an accident or vandalism.  But without your ability to see in that mirror, you could be driving blind, unable to see drivers approaching from the rear in adjacent lanes.  Sometimes it's as simple as having the glass replaced.  You'll greatly enhance your safety if you do.

Then there's the door mirror that you can't adjust.  First, let's look at a common scenario in later models, the power mirror.  They're great when they're working, awful when they're not.  Sometimes the motor fails, the switch goes bad or the wiring fails to deliver power.

Or how about the manually-adjusted door mirror that has either frozen up or just flops around? In this case, the mechanism has corroded, jammed up or a part has broken.  In both power- and manually-adjusted door mirrors, it sometimes can be hard to keep them in the right position.  Plus, every time there's a driver change, it may be hard to adjust those broken mechanisms by hand.

Finally, heated door mirrors can be extraordinarily useful in eliminating fogging or icing up in certain weather conditions.  But those heating elements can fail, switches can break or wiring can go bad.  Suddenly your fogged over, frozen mirrors aren't doing you any good at all. 

Good drivers use those outside rearview mirrors all the time.  They should be working the way designers intended, to provide the driver with vital traffic position information.  That's the kind of safety device you should get fixed or replaced sooner rather than later.  It's well worth it if you prevent even one little accident. 

Spring Street Automotive Inc
1701 Spring Street
Quincy, IL 62301
217-228-9141
http://www.springstreetauto.com

Automotive Tips from Spring Street Automotive Inc: Battery Testing

The simple fact is that 70% of car batteries fail within 4 years. They just need to be replaced at Spring Street Automotive Inc when they are no longer able to hold a full charge.

Batteries are a big ticket item for most Quincy drivers and it’s tempting to put off buying a new one as long as possible. But a battery that cannot hold a full charge requires the alternator to work extra hard, causing it to wear out prematurely.

Your Spring Street Automotive Inc service advisor can test your battery to see if it should be replaced. Testing is a good idea for IL drivers because a battery might still be good, but become dead because of a bad alternator or even a worn serpentine belt and tensioner.

Spring Street Automotive Inc
1701 Spring Street
Quincy, IL 62301
217-228-9141
http://www.springstreetauto.com

Start Me Up (Ignition Systems)

When you start up your gasoline engine car, you may not know that it's using the same ignition principles as it has for decades.  You have spark plugs that require enough power so a spark can jump across a gap at its tip.  Years ago, a vehicle's 12-volt system had to produce 15,000-25,000 volts to do that, so engineers came up with something called an ignition coil that bumps up the voltage. It also has to be done at just the right interval called timing.

The first systems had a distributor, a mechanical device with a rotating disc that switched the power to the ignition coil on and off.  That higher voltage then was sent to the spark plugs at the correct time interval. But the mechanical "points" had to be replaced and adjusted every 12,000 miles/20,000 kilometers.  Engineers later replaced the switching mechanism with solid state ones, but they still needed replacement after 120,000 miles/200,000 kilometers.

The next evolution came in the 80's when the distributor was replaced with a couple of sensors which talked to a computer.  This "DIS" (distributor-less automotive ignition system) was a big advance.  Plus, it didn't use just one ignition coil for all the cylinders.  It had coil "packs" that each provided spark to two cylinders.  That way, the voltage could be boosted even higher, to 30,000 volts, which helped engines be able to ignite a leaner fuel/air mixture.

Recently have come even more improvements.  Now instead of coil packs, there's a coil that's attached to each spark plug.  No more spark plug wires means less maintenance. Plus, a stronger, hotter spark of 50,000 volts can make an engine more reliable, increase fuel economy and reduce emissions.

No matter what ignition system your vehicle uses, your vehicle service facility has a staff of technicians trained to work on the latest technology.  Make sure to have your vehicle maintained regularly so you can take full advantage of these modern engineering marvels.

Spring Street Automotive Inc
1701 Spring Street
Quincy, IL 62301
217-228-9141
http://www.springstreetauto.com

Getting from E to F (Fuel Gauge Problems)

Who thinks about their fuel gauge?  You probably don't… until it doesn't work any more.  Then you have to guess how much fuel is in your tank, and that's no way to live life on the road. 

Fuel gauges, like every other part in your vehicle, can fail.  And when yours stops working, you will probably want to head over to your service facility soon, because no one relishes running out of fuel.

The fuel gauge system is much more than just the gauge you can see on your instrument panel. Most systems have a float inside the fuel tank that goes up and down depending on the fuel level.  It's called the fuel sending unit, and it sends an electrical signal to the gauge (on the dash) telling it to display how much fuel is left in the tank. 

So, what could go wrong?  Well, a few things.  For one thing, corrosion from bad fuel can cause it to stick and it won't move up and down any more.  So you could fill up your tank and the gauge would still read Empty.  If a sending unit needs to be replaced, often the parts can be costly. The good news is that fuel sending units rarely fail and most drivers will never have one go bad.

Other things that can go wrong? An electrical problem could cause a fuse to blow and you won't get a reading at all.  A technician can figure out where that electrical problem is and how to repair it.  Finally, it's possible for the gauge itself (on the instrument panel) to fail.

One thing to keep in mind is if your fuel gauge isn't working, you might be tempted to carry around an extra container of fuel.  That's ok if it's outside the cabin, such as in the bed of a pickup.  But if you carry it inside the cabin or trunk, fuel fumes can be very dangerous for your health, even fatal.

A working fuel gauge gives you peace of mind… so you'll never have that "empty" feeling.

Spring Street Automotive Inc
1701 Spring Street
Quincy, IL 62301
217-228-9141
http://www.springstreetauto.com